Hello,

I am new in using Galaxy and I am working on .bam files generated by our sequencing platform, using the LifeScope software associated to ABI 5500 sequencer. I uploaded my files on a galaxy browser ( http://galaxy.raetschlab.org) and I tried to run cufflink assemble and quantify reads expression levels for each file. However, when I run cufflinks (using default parameters) the output is an empty file.
What is going wrong? Should I use special parameters? Are the .bam files generated by LifeScope suitable for cufflink analysis or should I transform the xsq ABI output in a fastq and then apply TopHat? 

I thank you very much for your help

Davide

---
Davide Degli Esposti, PhD
Epigenetic (EGE) Group
International Agency for Research on Cancer
Tel. +33 4 72738036
Fax. +33 4 72738322
150, cours Albert Thomas
69372 Lyon Cedex 08
France 




------------------------------------------------------------------------------------------------
This message and its attachments are strictly confidential. If you are not
the intended recipient of this message, please immediately notify the sender
and delete it. Since its integrity cannot be guaranteed, its content cannot
involve the sender's responsibility. Any misuse, any disclosure or publication
of its content, either whole or partial, is prohibited, exception made of
formally approved use.
------------------------------------------------------------------------------------------------