Hi I've started an alignment using the command line (Tophat v1.3.3). I've uploaded the files (accepted.bam) onto Galaxy and upon doing the Cufflinks analysis on the Galaxy interface, it shows an error. I had to look at the options. I've change the options to default and run it again but still the same error. Is the accepted.bam file not compatible with the Galaxy Cufflinks? Is there something I not doing? Kind regards Lizex Disclaimer This message is confidential and may be covered by legal professional privilege. It must not be read, copied, disclosed or used in any other manner by any person other than the addressee(s). Unauthorised use, disclosure or copying is strictly prohibited and may be unlawful. The views expressed in this email are those of the sender, unless otherwise stated. If you have received this email in error, please contact ARC Service Desk immediately. (mailto:Servicedesk@arc.agric.za) To report incidents of fraud and / or corruption in the ARC use our Ethics Hotline by: Phone number : 0800 21 20 56 Fax number : 0800 200 796 Email address : fraud@kpmg.co.za For more information on the ARC Ethics Hotline, please visit our website at www.arc.agric.za.