Fetch Taxonomic Representation on dataset is blank
Hello All I ran a metagenomic analysis on a large dataset, larger than any of the others that I have run successfully. Joining two megablast queries resulted in 370, 163, 941 lines in tabular format. I then ran Fetch taxonomic representation on the data It ran with no error messages however when it was done approximately 3 days later, it was a empty file. Why does this happen? The previous dataset with 16,017,326 lines ran successfully If I redo it, how do I know that three days from now, it will not come back empty again? any suggestions? thanks Ameena
Ameena: Can you share your history with me? Thanks, anton galaxy team On Sep 27, 2010, at 2:40 PM, Ameena Nalim wrote:
Hello All I ran a metagenomic analysis on a large dataset, larger than any of the others that I have run successfully. Joining two megablast queries resulted in 370, 163, 941 lines in tabular format. I then ran Fetch taxonomic representation on the data It ran with no error messages however when it was done approximately 3 days later, it was a empty file. Why does this happen? The previous dataset with 16,017,326 lines ran successfully If I redo it, how do I know that three days from now, it will not come back empty again? any suggestions? thanks Ameena
_______________________________________________ galaxy-user mailing list galaxy-user@lists.bx.psu.edu http://lists.bx.psu.edu/listinfo/galaxy-user
Anton Nekrutenko http://nekrut.bx.psu.edu http://usegalaxy.org
participants (2)
-
Ameena Nalim -
Anton Nekrutenko